Up
For sale is a new old stock military surplus Timken tapered roller bearing bearing 15123/15245.
Some of its applications include front wheel sets on Chrysler 1949-1956 vehicles, and many others.
``Hudson Wheel Bearings Here are the bearing cup and cone numbers, these are from the Hudson parts book and NAPA can use them to get you what you need as I just bought these same bearings for my car. Front inner cone Timken #15123, front inner cup NAPA #15245. The outer bearing numbers for good measure are cone Timken #09067, cup Timken #09195. A note on bearings the numbers are usually (but not always) stamped on the bearing and the cup, your parts house or a local bearing house to get you what you need can reference these. Also for good measure here is the NAPA seal number for you #16246. Check that the cups pressed into your hub have not `spun` in the hub as this is what happened to me and I\u2019ve been told it is a relatively common occurrence. ''
``I was able to find an aftermarket kit to replace the bearings and seals on the front of my MF50. There is a MF part number for this kit. It is 835964M91. The box the kit came showed it would fit the following tractors: TE20, TO20, TO30, T035, MF35, MF40 (most likely an F40), MF50 AND MF65 STD.''
Technical Characteristics ( ILs ) 3110-00-275-0283
MRC Requirement Reply
SR-1 DEFINITIVE GOVERNMENT SPEC/STD REFERENCE AA59659-091
ABMK OVERALL WIDTH 0.7150 INCHES NOMINAL
ABXV BORE DIAMETER 1.2500 INCHES NOMINAL
ADGA OVERALL OUTSIDE DIAMETER 2.4410 INCHES NOMINAL
AGWU BACKFACE CORNER RADIUS 0.0460 INCHES NOMINAL
AGWV STANDOUT WIDTH 0.1525 INCHES NOMINAL
AGWW CONE CORNER RADIUS 0.1400 INCHES MINIMUM AND 0.1870 INCHES MAXIMUM
AGWX CONE WIDTH ANY ACCEPTABLE
CTFZ STANDARD TOLERANCE DESIGNATION AFBMA CLASS 2
SR-1 MANUFACTURERS CODE 58536
SR-1 NON-DEFINITIVE GOVERNMENT SPEC/STD REFERENCE A-A-59649
SR-1 MANUFACTURERS CODE 58536
MATT MATERIAL STEEL OVERALL
STYL STYLE DESIGNATOR 370 STRAIGHT BORE, DOUBLE CUP, SINGLE CONES
AGWY CUP WIDTH 0.5625 INCHES NOMINAL
